Do not use this product on patients with known allergies to this material and/or glass polyalkenoate cements.
2. Operators with known allergies to this material and/or glass polyalkenoate cements should exercise caution while using this product.
3. In case of any inflammation or other allergic reactions in either patient or operator, immediately discontinue use and seek medical advice.
4. Use protective gloves and glasses to avoid sensitization to this product. In case of accidental contact with oral soft tissue or skin, immediately blot with alcohol moistened cotton ball, and rinse with plenty of water. In case of contact with eyes, immediately flush eyes with plenty of water and seek medical advice.

• Pressed all-ceramic
• Veneers, inlays/onlays, crowns/bridges
• CAD/CAM all-ceramic
• Feldspar blanks, alumina and zirconia blanks
• Metal-free and metal-bonded procelains
• CTE range of 6.0-16.0 x 10-6K-1, firing temperature approx. 880 °C

• Telescopic pliers (5)
  Titanium ceramics (9)
  Tweezers (7)
  Vacuum pumps (2)
  Veneer resins (272)
  Veneers (15)
  Fixation (299)
  Prosthetics (1105)
  Orthodontics (392)
  General lab supplies (1501)

• High fusing single layer porcelain for metal free restorations
• Vintage ZR Uni Layer is a modern leucite reinforced single layer porcelain, with offers an economical alternative to monolithic all zirconium restorations.
• The Uni-Layer porcelain is based on the vintage ZR feldspar porcelain with its crystal structure, which offers a homogeneous firmness and is still gentle on the antagonist.

• Shadow-free illumination
• Fast and complete polymerization
• 7- segment LED display Visible display of time remaining
• Manual up/down control of curing table
• Easy and accurate adjustments
• Lamp life indicator Detects when lamps are dead Easy lamp replacement
• Saves time and reduces down time
• Solidilite’s footprint (W9xD93 /4xH131 /2 in.)

A-1. Cleaning of tooth surface Thoroughly clean the tooth surface to remove plaque

A-2. Shade selection Select appropriate shade using a shade guide while the tooth is still moist

A-3. Cavity preparation Prepare the cavity following the conventional method

A-4. Isolation Isolate with a rubber dam

A-5. Pulp protection In the case where the affected area is close to the pulp, cap the pulp with calcium hydroxide etc

• Improved GlasIonomer FX II features superior mechanical properties and exceptional handling characteristics for superior clinical performance.
• Enhanced aesthetics with high translucency, fluorescence close to natural teeth and optimal polishability.

• High resistance to compression 149 MPa compared with competitive cements
• Low film thickness, 15 microns optimizing the marginal integrity
• Radiopacity 1,55mm
• Low level of acid erosion 0,02mm
• High fluoride release
• Capsules with 0,53g
• Working time 4 minutes and 10 seconds from start of mixing
• Excellent track record that offers a low film thickness of 18 μ, higher compressive strength, excellent bonding to tooth structure and low water solubility for long lasting restorations.

• Improved GlasIonomer FX II features superior mechanical properties and exceptional handling characteristics for superior clinical performance.
• Enhanced aesthetics with high translucency, fluorescence close to natural teeth and optimal polishability.
• Excellent packable consistency ideal for posterior restoration of deciduous teeth or intermediate restoration of permanent teeth.